I installed the levers that hold down the solar array when it’s not tipped up:

The air conditioner cowling was cracked, so I patched it with leftover plastic from the earlier screen door repair:

I decided to remove this hood over the bathroom vent:

The fan also needs upgrading:

New fan installed:

The lower edge of the screen door needed fixing:

I installed the inverter’s remote switch and a shunt and display that shows live power consumption and battery state:

Shunt wiring:

The refrigerator’s exhaust was entering the cabin through an opening above its upper edge, so I walled it off.  This will ultimately be a cabinet:

Shower curtain installed:

The trim and underlayment was sagging due to water damage, so I glued it back up into position:

I fabricated this foam “floor” for the truck camper so the 5th wheel mount rails wouldn’t be a high point upon which the truck camper would rock back and forth:

Blinds installed:

Struts for tipping the solar panels fabricated and installed:

The lower screen and the plastic handle cover were both missing, so I replaced them:

I installed the inverter, solar controller, and solar panel shutoff switch:

Designing the bench platform was next:

Bench done, paramotor in place:

Pre-charged pressure tank installed: